Filter
Top Products
Filtering and treating water
In most areas it will be beneficial to filter or
treat the water being supplied to the ice
machine. It can improve the reliability of the
machine, reduce water system maintenance
and produce the best quality of ice.
The installation of a polyphosphate feeder will
generally reduce scale build-up and the ice
machine will require less frequent cleaning.
Municipal water systems are generally treated
with chlorine to maintain a safe potable water
supply. Activated carbon filters will sufficiently
remove the residual chlorine from the water to
reduce surface staining of stainless steel mate-
rials in the ice machine
For information on filtering and treating the
water, see the dealer from whom you pur-
chased your ice maker or your WHIRLPOOL
Franchised TECH-CARE” service company.
To shut down the ice maker:
Vacation and moving care
!
1. Turn the Cycle Control Knob to “OFF.”
2. Remove all ice from storage bin.
3. Shut off the water supply.
4. Remove two screws from base of front grille,
then remove front grille.
OUTLE;\I! 1
INLET
T
,
-
5. Disconnect the inlet and outlet lines to wate
valve. Allow these lines to drain and then
reconnect to the valve.
6. Replace front grille and screws.
7. Remove water from drain lines and
drain water pan if the unit will be subjected
to freezing temperatures during shut down.
8. Before using again, clean the ice maker
and storage bin.
Note: All components of the ice maker are permanently lubricated at the factory. They shou!d
not require any additional oiling throughout the normal life of the machine.