Filter
Top Products
Using your refrigerator
Temperature Control
Air Control
Air Outlet
I SI. ,’
7 :y #:
-. ‘::s,u&l
Power Saving Control
Setting the controls.. .
The Temperature Control is in the refrigerator and
the Air Control is in the freezer section. When the
refrigerator is plugged in for the first time..
54@2’
g5
3
I, Set the TEMPERA-
2. Set the AIR CON-
TURE CONTROL to 3.
TROL to 3.
Changing the control settings.. .
If you need to adjust temperatures In the refrlger-
ator or freezer, use the settings listed In the chart
below.
Give the refrigerator time to cool down com-
pletely before adding food.
(This may take sev-
eral hours ]
These settings should be about right for
normal household refrigerator usage.
The controls will be set about right when milk or
juice IS as cold as you like and when Ice cream
is firm.
Do not block the air outlet on the control panel.
Blocking it can slow the oir movement needed to
keep temperatures at the level you set.
l
Adjust the Temperature Control first
l
Wait at least 24 hours between adjustments
l
Then adjust the Air Control, if needed.
CONDITION:
REASONS:
If Refrigerator
Door opened often
Section is
Large amount of food added
TOO WARM
Room temperature too warm
RECOMMENDED SETTINGS:
Temperature Control
4
Air Control
3
If Freezer
Section is
TOO WARM
QUESTIONS?
. ..call your
If Refrigerator
COOL-LINEa Section
IS
service
TOO COLD
assistance
telephone
If ICE isn’t
number
MADE FAST ENOUGH
(page 15).
If BOTH SECTIONS
are TOO WARM
Door opened often
Large amount of food added
Very cold room temperature
(can’t cycle often enough]
Controls not set correctly
for your conditions
Heavy ice usage
Very cold room temperature
(can’t cycle often enough)
Door opened often
Large amount of food added
Very warm or very cold
room temperatures
Power Saving Control.. .
The Power Saving Control
on the Control Con-
Temperature Control
Air Control
Temperoture Control
Air Control
Temperature Control
Air Control
Temperature Control
Air Control
sole operates electnc heaters around the door
1 Use the “OFF” set-
openings. These heaters help keep moisture from
2. Use the “0N”setting
if moisture forms
forming on the outside of the refrigerator.
ting when humidity
IS
low. on the outside of the
refrigerator.