Whirlpool ED25SMIII Freezer User Manual


 
Cold Water and Ice Dispenser...
FOR ICE:
Press a sturdy glass against the
ice dispenser bar. (Pressure and
tumbling can break a fragile
we the glass to stop glass.) Remc
dispensing.
The first few batches of ice from
the ice maker may have a bad
taste. Throw them away This
from new plumbing and parts.
FOR CHILLED WATER:
Press a
sturdy
glass against the
water dispenser bar. (Pressure
can break a fragile glass.) Re-
move the glass to stop
dispensing.
If the dispenser is not used reg-
ularly, dispense enough every
week to freshen the supply Allow
2-3 hours for chilling.
The small, heated tray beneath the dispenser is designed to evaporate small spills.
There is no drain in this tray. Do not pour water
into It.
Ice Is dlspemsed
from the ice maker storage bin
Chllled water
comes from a tank behind the
in the freezer. When the dispenser bar is pressed, a
meat pan. It holds about 50 ounces (1.5 L).
trapdoor opens in a chute between the dispenser
When the refrigerator is first hooked up, press the
and the ice bin. Ice is moved from the bin and falls
water dispenser with a glass or a jar until you have
through the chute. When the dispenser bar is re-
drawn and discarded 2 cr 3 quarts (1.9 to 2.8 L).
leased, a faint buzzing sound may be heard for a
Only air will came out to start with.
The
water you
few seconds.
draw and discard will rinse the tank and pipes.
Allow about 24 hours to chill the first tankful.
Common Problems
PROBLEM
Dlspenser won’t
work.
Ice dlrpenser won’t
work.
Ice dlspenser stops
worklng.
Ott-taste or odor
In Ice.
CAUSE
Freezer door open.
Ice bin not properly installed.
Wrong ice in ice bin.
Ice dispenser bar held in too long.
Ice attracts airborne odors.
Old ice.
Water quality.
Foods not properly wrapped.
Ice bin and freezer may need
cleaning.
Plumbing to ice maker:
New ice maker.
SOLUTION
l
Close the freezer door.
l
Make sure bin is pushed all the way in.
l Use only ice crescents from Ice maker.
Other shapes won’t dispense properly.
l
Wait about 3 minutes for the dispenser motor
to reset.
Large amounts of ice should be taken from
the bin,
not through the dispenser.
l
Use rapidly or store in covered container:
l
Dump old ice and make new supply
l
Water containing minerals (such as sulfur]
may require a filter to remove.
l
Wrap properly See pages 13 and 14.
l
Clean freezer and ice bin. See Cleaning
Chart on page 11.
l
Follow installation instructions for proper ice
maker water supply hook-up.
l
The first few loads of ice from a new ice
maker may have an off-taste. Dump ice and
make new supply.
8