Whirlpool ED26MM Refrigerator User Manual


 
Removing
the Roll-Out Shelf.. .
Removing the crisper, meat pan
and covers.. .
l
Slide crisper and meat pan straight out to stop.
l
Lift the front.
l
Slide the rest of the way out
l
Replace in reverse order.
Lift Out the Tray
Tilt the Front;
Lift the Back
The tray rests on a frame that slides out fcr
easy loading or unloading It should be the bottom
shelf in your arrangement
The tray lifts out of the frame The frame Itself is
removed and replaced just like the shelves.
-mm
Removing freezer shelves.. .
l
Lift front slightly.
?
l
Lift back off supports.
c
l
Replace in reverse order. D
7
Lift the Front
Then the Back
Removing the freezer basket.. .
For proper air movement, keep the freezer basket
In place when the refrigerator IS operating.
To remove the basket:
l
Slide out to the stop.
I-
O Lift the front to clear _
the stop
l
Slide out the rest
of the way
To replace
the basket:
l
Place basket on the slrdes
l
Make sure the wire stops
clear the front of theslides
l
Slide basket In
8
Push the Tab
to Clear the Cover.
l
Covers are held in place by two pegs at the back
and two notched tabs In front.
- Press front tabs out of the way.
-Lift cover front.
- Lift back off the pegs.
- Replace in reverse order
Changing light bulbs...
Before removing a light shield for cleaning or for
replacing a bulb, unplug the refrigerator. Use op-
phonce bulbs only
Pull Out at the
Light bulbs behind retrigerator and freezer
control consoles:
-Pull control knob straight off.
- Pull bottom of control panel straight out.
-Lift top of panel off suppcfts.
-Replace wrth a 40.watt appliance bulb.
- Replace panel In reverse order.
l
light bulb behlnd ice maker:
- Remove the ice brn [see ice maker Instructions
page6).
- Replace with a 40-watt appliance bulb.
- Replace Ice bin
l
light bulb above crisper:
-Pull top of the light shield away from the back
wall.
- Lift shield off base supports.
- Replace with a 40-watt appliance bulb
- Replace shield in reverse order.
l
Dispenser light:
- Reach the bulb through the dispenser area
- Replace with a heavy-duty IO-watt bulb.