Filter
Top Products
Install properly...
1, Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from In-
flammables such as gasoline.
3. Allow at least 3 inches (7.5 cm] air space on all
sides of freezer and 2 inches (5 cm] at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the lid during
installation. If, for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer.
5. Do not cover the freezer wtff-~ items such as
blankets, sheets, tablecloths, etc.
Level chest freezer...
from end to end and front to back so that the lid will
seal properly.
Check with level
Remove sales labels...
Remove the Consumer Buy Guide label and any
lnslde labels before using the freezer.
To remove any remalnlng glue:
1. Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described in step I,
DO NOT USE rubblng alcohol or flammable or
toxic solvents, such as acetone, gasollne, car-
bon tetrachlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE the Care and Service
label on inside of lid or the Tech Sheet on back
of cabinet.
Install defrost drain cover...
I. Remove cover from literature package.
2. Check drawing on front cover for placement
3. Install coveK
Clean it . . .
Clean your freezer before
using it. See cleaning
instructions on page 6.
Plug it in...
-
3-prong grounding
type wall receptacle
Retaining Clip
Freezer /
Power Plug
\
3-prong
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided. Use a
receptacle which cannot be turned off wlth a
switch or pull chain. Do not use an extenslon
cord.
Attach retaining clip over power cord plug
from literature package inside the freezer.
4