Filter
Top Products
The interior light...
WARNING: To avoid possible shocks, first unplug
freezer or turn off electricity leading
to freezer at the main power supply.
To replace:
1 Remove the light bulb
2 Replace bulb wrth a E-watt appliance bulb.
3 Plug in power cord or switch on electricity.
The signal light...
automatically warns of any unexpected power
failure.
If the signal light is not glowing, immediately check
l
for power interruption,
l
for an unplugged power cord,
l
for a burned out signal light
I
@
J
Energy Saving Tips...
l
Check lid gasket and level cabrnet to ensure a
good lid seal. Keeping freezer locked ensures Ird
closure
l
Keep Ird openrngs to a mrnrmum Remove several
items at one time. Keep contents organtzed to elrmr-
nate searching
To replace:
1. Unplug power cord from outlet.
2 Carefully snap out light cover and assembly with a
screwdriver by inserting it under the end of metal
edge of the light Be careful not to chip finish on
freezer
3 Unplug burned out signal light and replace with a
new one. Signal light can be ordered from your
WHIRLPOOL dealer.
4. Then, snap light assembly into place.
5. Plug power cord into outlet.
l
Fill to capacity Follow recommended procedures
for freezing foods.
l
Set Temperature Control to provide temperatures
around 0°F ( ~ 17.8”C). There is no need to store f&s
below 0°F.
l
Do not let frost build up to more than Y4 Inch
(6 mm) thick.
Cleaning your freezer
This freezer should be cleaned when frost has burlt up to about % Inch (6 mm) thickness.
Complete defrosting and cleaning should be done at least once a year.
In high humidity areas, a freezer may need more frequent defrosting.
To defrost and clean:
1 Unplug freezer
2 Take out all fro-en food and sliding baskets.
NOTE: Wrap frozen foods and packages in several
layers of newspaper and cover with a blanket Food
will stay frozen several hours
3 Remove drain cover by pulling out.
4 Insert hose adapter provided into drain outlet
5. Remove rubber stopper from inside bottom of
After defrosting:
freezer
1 Remove hose adapter.
6. Place a pan under the drain, or attach a hose to the
2. Replace drain cover and rubber stopper.
threaded end of the adapter and direct water into
3. Plug in freezer
a separate drain.
I Clean freezer according to the following dlrec-
tions.
4 See directions for “Setting the Temperature Con-
trol:’ page 5
6