Install properly..
Install defrost drain cover...
I. Remove cover from literature package
2. Check drawing on front cover for placement
1 Check the strength of the floor It should hold the
weight of a fully loaded freezer
2 Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow at least 3 Inches (7.5 cm) arr space on all
sides of freezer and 2 inches (5 cm) at back. Leave
room at top for lid to open all the way.
4. It should not be necessary to remove the Ird during
installation If, for any reason, the hinges need ad-
justment, see your authorized WHIRLPOOL dealer.
5. Do not cover lhe treezer with items such as
blankets, sheets, tablecloths, etc.
Level chest freezer.. .
from end to end and front to back so that the lid will
seal properly
Check with level
Clean it . . .
Clean your freezer before
using It See cleaning
rnstructrons on page 6
Plug it in...
3-prong grounding
type wall
receptacle
Retaining Clip
Freezer /
Power Plug
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrIcal supply is re-
Remove sales labels...
qurred. It IS recommended that a separate circuit
Remove the Consumer Buy Guide label and any
servtng only this dpplrance be provided
inside labels before usrng the freezer
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
To remove any remaining glue:
or pull chain. See rndivrdual electrrcal require-
1 Rub briskly wrth thumb to make a ball. then
ments and grounding instruction sheet In your Irter-
remove ature package
OR
2 Soak area with drshwashrng detergent solution (1
teaspoon detergent In 1 quart warm water] be-
fore removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ihe Care 81 Service label
on Inside Ild or Tech Sheet on back of cabinet.