Using your freezer
Setting the temperature control...
Adjusting the temperature control..
1
Insert a coin in the slot of the Temperature Control to
turn it.
2 Turn control to Number 3 Thts setting IS destgned to
matntatn the temperature at or near 0°F (
17 8°C)
under normal operating condittons
The sliding baskets...
Can be moved from side to side or removed when
loading or unloading food below them.
To remove:
L1f-t basket oul
To replace:
1 ower basket Into place
The key eject lock...
can help reduce the hazard of child
entrapment
The signal light...
automatically warns of any unexpected power
fatlure
If the signal ltght
IS
not glowtng, tmmedtately check:
l
for power Interruption,
l
for an unplugged power cord,
l
for a burned out signal Ilght
I
fE@
J
1 Turn control to higher number for colder temper-
atures
2 Turn to lower number for less cold temperatures
Cooling freezer first...
1 Allow freezerto cool 6 to 8 hours before ftllrng with
frozen food.
2 Let It cool overnight before adding large amount
of unfrozen food.
Note: When freezer IS first started, the compressor
WIII run constantly until the cabinet IS cooled It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door
IS
opened
After the cabinet IS cooled, the compressor will
turn ON and OFF as needed to keep the freezer at
the proper temperature
To lock or unlock the freezer you must hold the
key in the lock while turntng. The lock is spring
loaded so the key cannot be left in the lock
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
WARNING: To avoid possible shocks, first unplug
freezer or turn off electricity leading
to freezer at the main power supply.
To reDlace:
Unplug power cord from outlet.
Carefully snap out light cover and assembly with a
screwdriver by inserting it under the end of metal
edge of the light. Be careful not to chip finish on
freezer.
Unplug burned out signal light and replace with a
new one. Stgnal light can be ordered from your
WHIRLPOOL dealer.
Then, snap ltght assembly into place
Plug power cord Into outlet
5