Filter
Top Products
Range must be secured when mobile
home is moved and at all times in a RV.
recreational vehicle using the method
descrlhed.
Pull bottom of front Dane1 out end lift UD
to remove panel. Removing levehng
-
legs.
16
Secure be range using 6/16” bolts,
washers and nuts through the leveling
leg holes. Replace lower access panel.
Skip step 17.
Place rack in oven. Place
n
level on rack, first side to side;
then front to back If range is not level at
the tiont, adjust the leveling legs up or
down until the range is level. If reer of
range needs adjusting, adjust rear
leveling legs up or down until range is
level. If rear legs sre adjusted downward
more than l/8”. add shims under anti-tip
bracket. Replace front panel.
Note: Oven must be level for satisfactory
baking conchtlons.
4-wire electrical connection
Use this wirhg method for mobile homes
and whenever 4-wire installation Fs
required
Personal Injury Hazard
Carefully remove the rear access
panel when attaching the power
supply cord. The rear access panel
contains a counterweight box
making it heavier than it appears.
Failure to follow this h~truction
may result in penonal Lniury.
Take the strain relfef from the
power supply cord kit end insert it
into the hole below the terminal block.
Insert the power supply cable through
the strah relief ellowhg enough slack to
easily attach to the terminal block.
B
Remove the grounding link from
. the terminal block. Remove the
green grounding screw and place it with
your other parts.
To get the most efficient
use from your new Roper range,
read your Roper Use and Care
Guide. Keep Installation
lnatrucrione and Guide close to the
range for easy reference.
5. 6.
7. 8.
--
C
Connect the green grounding
n
wiretotherangeusfngthe
grounding screw removed in Step B. The
green growding wire must be attached
first and must not
contact
any other
.--
D
connect the neutral
(white)
. wire to the center, silver-colored
tmminal screw on the termhal block.
Connect the other two wires to the outer
terminals on the terraInal block. Use ring
type tembals only. Attach washers and
hex nuts
aUDDlied
in the
PUtS Packaee.
Check that dirts ere tight-to tn.&e proper
electrical connection
E
Tighten the strain relief screws.
m Replace access panel.
F
Contluue hstallatIon at Step 9,
m PanelB.
Numbers
correspond
to steps.
13. 14. 15. 16. 17.
Panel C