Filter
Top Products
Install properly.. .
Remov? sales labels..
l
1. Allow 3 inches (7.5 cm) between overhead cabi-
nets and refrigerator top.
2. Allow at least an inch (2.5 cm] between the
refrigerator condenser on the back and the wall.
3. Allow % inch (1.25 cm] on each side of the
refrigerator for ease of installation.
4.
If
the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider
Level refrigerator-freezer.. .
Raise
lower
1. Keep the 4 bolts that hold refrigerator in shipping
crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator.
3. Adjust each until the refrigerator won’t rock.
4. Slide the refrigerator into place.
5. Adjust front legs to level the refrigerator.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
6. Check with level.
Remove the Consumer Buy Guide label, tape and
any
lnslde
labels before using the refrigerator.
To remove any remalnlng glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline,
car-
bon tetrachlorlde, etc. These
can
damage the
matertal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the reirlgemtor at the tront.
Clean it.. .
Clean your refrigerator
before using it.
See cleaning instructions
on page 8.
Plug it in...
J-prong grounding
type wall receptacle,
11111 ‘II
J-prong
A
groundlng plug
1
Refrigerator
Power Cord
RECOMMENDED GROUNDING
METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See Individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4