Filter
Top Products
Adjusting the refrigerator shelves...
To remove the shelves:
1. First, remove food from shelf.
2. Slide shelf straight out to the stop.
3. Lift front, slide shelf the rest of the way out.
To replace the shelves:
1. Flt back of shelf on top of guides with wire
on the bottom of guides.
2. Lift front, slide shelf in until it clears guide
WIDE
Removing crispers and crisper cover.
,.
LIFT THE FRONT, THEN THE BACK.
-
PUU OUT TO THE STOP.
LlFr
THE FRCNT AND PULL A@AIN.
To remove the crlspers:
1. Slide crisper straight out to the stop, then slide
the rest of the way out.
2. Replace in reverse order.
To mmovo the cover:
1.
Lift front and remove the cover support.
2. Lift out cover by pulling up and out.
To replace the cover:
1. Fit back of cover into notch supports on wails of
refrlgerator, then lower front into place.
2. insert cover support (with the long tab toward
the front) into the groove on the underside of the
crisper cover. NOTE: If support needs adJust-
merit, turn base right to raise, or Iotl to lower.
Changing the light bulb...
Electrical Shock Hazard
Beiore removing the light bulb, elther unplug the retrlgerator or dlscon-
nect the electrlclty leadlng to the ntrlgerator at the maln power supply.
Shock and InJury can occur It electrlclty remalns connected.
1.
Disconnect refrigerator from power supply.
2. Reach behind the Control Console to find bulb.
3. Remove bulb.
4. Replace with a 40-watt appliance bulb.
5. Reconnect power supply.
Reversing the door swing...
You can change the hinges on your refrigemtor
so he doors open the other way. You will need a
#20 Torx head screwdriver. Refer to the instructlon
sheet included with your refrigerator.
6