Whirlpool ET16AK Refrigerator User Manual


 
Install properly.. .
1. Allow 3 inches (7.5 cm] between overhead cab-
inets and the refrigerator top.
2. Allow at least an Inch (2.5 cm) between the refng-
erator condenser and the wall.
3. Allow % inch (1.25 cm] on each side of the re-
frigerator for ease of rnstallation.
4. If the refrigerutor is to be against a wall, you might
want to leave enough space so the door can be
opened wider
Level refrigerator-freezer...
Use Screwdriver
leveling screw
to Adjust
left to lower
1 To raise front, turn each screw to the right
2 To lower front, turn each screw to the left
3 Check with level
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator.
To remove any remalnlng glue:
1.
Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet tastened under
the refrlgemtor at the front.
Clean it.. .
Clean your refrtgerator before using it. See clean
rng instructions on page 8
Plug it in...
Refrigerator
Power Cord
RECOMMENDEDGROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extenslon cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4