Whirlpool ET16AK Refrigerator User Manual


 
Moving the meat pan and cover...
Removlng:
The meat pan and cover can be removed for
cleaning and moved to another shelf, if desired.
Remove the meat pan first.
I. Slide meat pan out to stop.
2. Lift the front of meat pan.
3. Slide pan the rest of the way out.
4. To remove cover, push up glass insert from bottom,
Cover Frame
Changing the light bulb.. .
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re-
frigerator at the main power supply.
Shock and injury can occur if elec-
tricitv remains connected.
then lift out with both hands.
5. Lift cover frame straight up and out.
Replaclng:
1. To replace cover, fit notches in cover frame sides
over center shelf support.
2. Lower cover frame into place.
3. Lower glass insert into cover frame
4. To replace pan, fit edges of pan into supports on
covet
5. Slide meat pan into place.
1. Reach behind
contrbi consdle to find bulb.
2. Remove bulb.
3. Replace with a 40-watt appliance bulb.
Removing crispers and crisper cover.. .
Pull out to Stop. Lift the Front
and Pull Aaain.
Glass Insert,
Lift the Frame Front,
Removing the Crispers:
1. Slide crisper straight out to stop, lift front, then slide
the rest of the way out.
2. Replace in the reverse order.
Removing Cover:
I. Push up glass insert from bottom, then slide out
with both hands.
2. Lift front of cover frame and remove cover support
3. Lift out cover frame by pulling up and out.
Replacing Cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab
towards the front.
Note:
If the support needs
adjustment, turn base right to raise, or lefi to lower.
3. Slide back of glass insert into place, then lower front.
Adjusting the refrigerator shelves...
7. First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out.
Replacing Shelf:
Guide Stop
Shelf Stop
1, Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf in until it clears guide stops.
Removing and adjusting the
To remove shelf:
1. Lift front slightly
2. Lift back off supports.
3. Replace in reverse order.
To adjust shelf:
1. Remove shelf
2. Remove supports by sliding upwards
3. Replace supports on desired level.
4. Replace shelf.
6
I