Filter
Top Products
Install properly.. .
1. Allow 3 inches (7.5 cm) between overhead cabi-
nets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the
refrigerator condenser on the back and the wall.
3. Allow ‘/2 inch (1.25 cm) on each side of the
refrigerator for ease of installation,
4. If the refrigerator is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider,
-F~~rFiE
.- .,
‘-.-*,s 2IIR%,1 . .‘. ‘.I *I .:...-seil
Level refrigerator-freezer.. .
II
Leveling screw
Raise
Use Screwdriver
to Adjust
Right to Raise;
Left to Lower
1. To raise front, turn each screw to the right
2. To lower front. turn each screw to the left
3. Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
Inside
labels before using the refrigerator
To remove any remaining glue:
I, Rub briskly with thumb to make a ball then remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described in step I.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachlorlde, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator
before using it. -
See cleaning instructions
on page 9
Plug it in...
3-prong grounding
type wall receptacle
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.
4