Filter
Top Products
Install properly...
a
IIl,I
cl
I I
i-l
.
Remove sales labels...
1. Allow 3 inches (7.5 cm] befween overhead cab-
inets and refrigerator top.
2. Allow at least an inch (2.5 cm) between the re-
frlgerator condenser on the back and the wall.
3. Allow YZ inch (1.25 cm) on each side of the re-
frigerator for ease of Installation.
4. If the refrigerator is to be against a wall, you
mlght want to leave extra space on the hinge
slde so the door can be opened wider.
Level refrigerator-freezer.. .
LEVELLING SCREW
USE SCREWDRIVER
RIGHT TO RAISE;
TO ADJUST
LEFT TO LOWER
1. To raise front, turn each screw to the right.
2. To lower front, turn each screw to the left.
3. Check with level.
Remove the Consumer Buy Guide label, tape
and any Inside labels before using the re-
frigerator. To remove any remainlng glue:
1. Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasollne, car-
bon tetrachlorlde. etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrlgemtor at the front.
Clean it...
Clean your refriger-
ator before using it.
See cleaning instruc-
tions on paqe 8.
Plug it in...
I-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
POWER CORD
J-PRONG
GROUNDING PLUG
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused
and properly grounded electrical supply is
required. It is recommended that a separate cir-
cuit serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package.