Filter
Top Products
Changing the light bulbs...
2. Remove bulb.
3. Replace with a 40.watt appliance bulb.
r.. ./
_I z .3lkkw
~~~~.‘ii~. Al i. ^.
Removing the base grille...
To remove the grille:
r
METAL CLIPS
7
SUPPORT TABS
1. Open the door.
2. Pull grille outwards as shown.
1. Line up grille support tabs with metal clips.
3. Do not remove Tech sheet fastened behind
2. Push firmly to snap into place.
grille.
3. Close the door.
Ice cube trays...
(Model ETPOGK)
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation. The longer
cubes are stored, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Slightly twist.
Automatic ice maker...
If you have Model ET20GM and have the auto-
matic ice maker accessory, or if you have Model
ET20GK and plan to add one later (Part No.
ECKMF-831, there are a few things you will want to
know:
l
The ON/OFF lever is a wire signal arm.
Downfor making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
RAISE
SIGNAL
ARM TO
STOP ICE
l
The dial or lever on the side of the ice maker
l
The ice maker will not operate until the freezer
changes the size of the cubes.
is cold enough to make ice. This can take
l
Shake the bin occasionally to keep cubes sepa-
overnight.
rated, and to obtain increased storage capacity.
l
Because of new plumbing connections, the first
l
It is normal for ice crescents to be attached by a
ice may be discolored or off-flavored. Discard
corner. Thev will break abart easilv.
the first few batches of ice.
l
You will hear water running when ice maker is
l
It ice is not being made fast enough and more
working. You’ll hear ice fall into the bin. Don’t let
ice is needed, turn the Refrigerator Control to-
these sounds bother you.
ward a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A.