Filter
Top Products
Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and
any
inside
labels before using the refrigerator
To remove any remaining glue:
1 Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] before
removing glue as described In step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
1 Allow % Inch (1.25 cm] space on each side and at
the top of the refrigerator for ease of installation
2. If the refrigerator
IS
to be against a wall, you might
want to leave extra space so the door can be
opened wider.
3 The refrigerator back can be flush against the wall
Level refrigerator-freezer.. .
Levetling SK4 1
Front Roller
Right to Raise,
Left to Lower
I. Remove base grille (see page 7 ).
2. To raise front, turn each screw to the right
3. To lower front, turn each screw to the left.
4. Check with level.
Clean it.. .
Clean your refrigerator
before using It
See cleaning instructions
on page 9
Plug it in...
3-prong grounding
type wall receptacle
grounding plug
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt. 60 Hz, AC only 15 or 20 ampere fused
and properly grounded electrlcal supply is re-
quired It
IS
recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain.
See lndlvldual electrical require-
ments and grounding instruction sheet in your liter-
ature package
.