Filter
Top Products
Changing the light bulb...
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re-
frigerator at the main power supply.
Shock and injury could occur.
Adjusting the refrigerator shelves...
Shelves can be adjusted to
match the way you use
your refrigerator.
If your model hos
gloss shelves
Glass
shelves are heovv
,i
Be careful
II I
Moving the meat pan and cover...
Model ETlBXK
The meat pan can be taken out and moved the
same way as the shelves. Remove the meat pan frrst.
Model EMBVK
Pull Out to Stop. Lifl the
Glass is heavy.
Front and Pull Again.
Be Careful.
Cover
Frame
Frame
support
2. Remove bulb
3 Replace with a 40.watt appliance bulb.
To remove shelves:
1. Tilt up at front.
2. Lift up at back
3. Pull shelf strarght out.
To replace:
1 Guide the rear hooks Into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slot. Lower
front of shelf to level position.
Removing the Meat Pan:
I. Slide the meat pan out to stop
2 Lrft the front of meat pan.
3 Slrde pan the rest of the way out.
4 Tilt cover up at front
5. Lift up at back.
6. Pull straight out.
Removing the cover:
1 Guide the rear hooks into the slots in the shelf
supports.
2 Tilt up front of cover until rear hooks drop into slots.
Lower front of cover to level posrtion
3 Replace meat pan in reverse order.
Removing the Meat Pan:
1. Slide the meat pan out to stop.
2. Lift the front.
3. Slide pan the rest of the way out
4. Replace in reverse order
Removing the cover:
I, Push up glass insert from bottom, then slide out
with both hands.
2. Lift cover frame out of frame support
3. Tilt front of frame support up, lift at back, and pull
support straight out.
4. Replace in reverse order
Removing crispers and crisper cover.. .
ill
’ I Dllll nII* *A Stop. Lift the Front
Removing the Crispers:
wEI’ ‘7:;
1, Slide crisper straight out to stop, lift front, then slide
the rest of, the way out.
2. Replace In the reverse order
Removing Cover: 6
-ii
1
=fP-h\‘r,
Push up-glass insert from bottom, then slide oul
with both hands.
6
h 2. Lift front of cover frame and remove cover support
3. Lift out cover frame by pulling up and out.
Rep,acing Cover
I, Fit back of cove/into notch supports on walls of
refrigerator, then lower front into place.
Lift the Frame Front, 2. Replace cover support with the long tab
then the Back.
towards the front. Note: If the support needs
Glass Is heavy.
adjustment, turn base right to raise, or left to lower.
Be Careful. 3. Slide back of glass insert into place, then lower front.