Filter
Top Products
Adjusting the shelves.. .
‘--&
GuideStoP h
Jtsz27-
h
I. First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4. Slide the rest of the way out.
ReDlaCina Shelt:
1. iit bacrof shelf on top of gurdes with wire stops
on the bottom of guides.
2. Lift front, slide shelf In until it clears guide stops.
Removing crisper and crisper
cover.. .
L~fl the Front. Then the Back
Pull out to stop
Lift the Front and Pull Agaln
Removing Crispers:
1 Slide crisper straight out to stop.
2. Lift the front
3. Slide the rest of the way out.
4. Replace In reverse order.
Removing Cover:
l
Lift front, then lift back.
l
Pull up and out.
Replacing Cover:
I, Frt notches on back of cover into back nubs on
wall of refrigerator.
2. Lower front into place.
Changing the light bulb.. .
WARNING: Before removing the light bulb, either
unplug the refrigerator or disconnect
the electricity leading to the re-
frigerator at the main power supply.
Shock and injury can occur if elec-
tricity remains connected.
I, Reach behind control console to find bulb.
2 Remove bulb.
3. Replace with a 40.watt appliance bulb
Automatic ice maker.. .
Shelf Stop
Raise Signal
Arm to Stop Ice Maker.
Lower Signal
Arm to Start It.
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-83). there are
a few things you will want to know:
l
The ON /OFF lever is a wire signal arm.
Down.. .for making ice automatically;
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain increased storage capacity.
l
It is normal for ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker IS
working. You’ll hear ice fall into the bin. Don’t let
these sounds bother you.
l
The ice maker will not operate untrl the freezer is
cold enough to make ice. This can take overnight.
l
Because of new plumbing connections. the first
ice may be discolored or off-flavored. Discard the
first few batches of ice.
l
If ice is not being made fast enough and more ice
is needed, turn the Refrigerator Control toward a
higher number. Wait a day and, if necessary, turn
the Freezer Control toward A.
l
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
positron.
l
If cubes are stored too long, they may develop an
off-flavor...lrke stale water. Throw them away. They
will be replaced. Cubes in the ice bin can also
become smaller by evaporation.
l
The ice maker water supply should not be Soft-
ened water. The chemicals could damage the ice
maker molds.
6