Filter
Top Products
Install properiy...
Remove sales labels...
1. Check the strength of the floor It should hold the
weight of
a
fully loaded freezer.
2. Pick a sate place, Indoors, away from In-
tlammables such as gasollne.
3. Allow 3 inches (7.5 cm) air space on top of freezer
for proper ventilation.
4. Allow at least an inch (2.5 cm) between the
freezer condenser, on the back of the unit, and
the wall.
5. Allow
1/2
inch (1.25 cm] on each side of the freezer
for ease of installation.
6. If the freezer is to be against a wall, you might
want to leave extra space on the hinge side so the
door can be opened wider.
7. The four bolts that held your freezer in the shipping
crate are designed to be the levelling legs. Screw
the legs far enough into the bolt holes, in each of
the four bottom corners, so the freezer stands
about 1 inch (2.5 cm) off the floor
Level freezer... c
Levelllng leg
Lower Rake
I, Keep the 4 bolts that hold freezer in shipping crate.
They ore the levelling legs,
2. Screw these bolts all the way into bolt holes at the
bottom corners of freezer. Move freezer into place.
3. Adjust each leg until the freezer won’t rock.
4. Adjust front legs to level the freezer.
- To raise corners, turn legs in direction shown.
- To lower corners, turn legs in direction shown.
5. Check with level.
4
Remove the Consumer Buy Guide label and any
Inslde
labels before using the freezer.
To remove any remalnlng glue:
I. Rub briskly with thumb to make a ball. then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) be-
fore removing glue as described in step 1.
DO NOT USE rubbing alcohol or ttammable or
toxic solvents, such as acetone, gasoline, car-
bon tetmchlorlde, etc. These can damage the
materlal.
NOTE: DO NOT REMOVE the Tech Sheet tas-
tened under the treezer at the front.
Clean it . . .
R
Clean your freezer before
using it. See cleaning
instructions on pages6.
Plug it in...
3-prong groundlng
type wall receptacle
Freezer
Power Cord
groundlng plug
Recommended Groundlng Method
.
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extenslon cord. Use a recep-
tacle which cannot be turned off wlth a switch
or pull chain. See
individual electrical require-
ments and grounding instruction sheet in your liter-
ature package.