Filter
Top Products
Install properly..
Remove sales labels...
1 Check the strength of the floor. It should hold the
weight of a fully loaded freezer.
2. Pick a safe place, indoors, away from in-
flammables such as gasoline.
3 Allow 3 inches (7 5 cm] air space on top of freezer
for proper ventilatron.
4 Allow at least an inch (2 5 cm] between the
freezer condenser, on the back of the unit, and
the wall
5 Allow
%
Inch !I.25 cm) on each side of the freezer
for ease of installation
6 If the freezer IS to be against a wall, you might
want to leave extra space on the hinge srde so the
door can be opened wider
Level freezer...
so the door will stay
open at any position
Raise
Lower
I, Keep the 4 bolts that hold freezer in shipprng crate.
They ore the levelling legs.
2 Screw these bolts all the way into bolt holes In the
bottom corners of freezer. Move freezer into place.
3. Adjust each leg until the freezer won’t rock.
4. Adjust front legs to level the freezer
-
To raise
corners,
turn legs in drrection shown
- To lower corners, turn legs in direction shown.
5 Check with level.
4
Remove the Consumer Buy Guide label and any
inside labels before using the freezer
To remove any remaining glue:
1 Rub briskly with thumb to make a ball, then
remove.
OR
2. Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water] be-
fore removing glue as described in step I,
DO NOT USE rubbing alcohol or ftammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
Clean it...
Clean your freezer before
using it. See cleaning
instructions on page 6.
Plug it in...
3-prong grounding
type wall
receptacle
Freezer
Power Plu
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and
properly grounded electrical supply is required. It is
recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or pull
chain. Do not use an extension cord.