Filter
Top Products
Using your freezer
Setting the Cold Control...
Coolinlg Freezer First...
To start, turn control to the middle of the dial.
This setting will mahtain zero zone temperatures
under normal operating conditions.
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let it l::ool overnight before adding large
amounx of unfrozen food.
l
Frost WIII form on the shelves. It will form first and
be hecvier on the top shelves.
i’
Adjusting Cold Control...
l
Turn control to higher number for colder
temperatures.
l
Turn to lower number for less cold temperatures.
Note: Wpen freezer is first started the compressor
will run constantly until the cabinet is cooled. It
may tak(l up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freeze:?r door is opened.
Afterttle cabinet is cooled the compressor will
turn on ilnd off as needed to keep freezer at
proper 1c>mperature.
The Power Saving Control...
operates electric heaters. These heaters help
prevent noisture from forming on the outside of
the freezerwhen humidity is high
l
Use thf:bOFF setting when humidity is low to save
electril.:ity.
l
Use O’\l only if moisture forms on outside of
freeze1
The Key Eject lock...
can help reduce the hazard of child
entrapment.
To lock or unlock the freezer you must hold the
key in the lock while turning. The lock is spring
loaded so the key cannot be left in the lock.
If the key is lost, contact your WHIRLPOOL dealer
for a replacement. Always give the complete
model and serial number of your freezer when
requesting a replacement key.
Bottom Trivet...
To remove.
l
Lift up, then pull out.
To replace.
l
Set in bottom of freezer.
l
Push into place.
Ii
Lift up
Then out
3