Filter
Top Products
Using your freezer
Setting the Cold Control...
To start, turn control to the middle of the dial
This setting will maintain zero zone temperatures
under normal operating conditions
Adjusting Cold Control . . .
o Turn control to higher number for colder
temperatures
l
Turn to lower number for less cold temperatures
Cooling Freezer First.. .
l
Allow freezer to cool 6 to 8 hours before filling
with frozen food.
l
Let tt cool overnight before adding large
amount of unfrozen food.
Note: When freezer is first started the compressor
will run constantly until the cabinet is cooled It
may take up to 6 to 8 hours or longer, depending
on room temperature and the number of times
the freezer door is opened.
Afterthe cabinet is cooled the compressor will
turn on and off as needed to keep freezer at
proper temperature.
I II
POWER SAVING CONTROL
I II
The Power Saving Control...
operates electric heaters. These heaters help
prevent moisture from forming on the outside of
the freezer when humidity is high.
l
Use the OFF setting when humidity is low to save
electricity.
l
Use ON only if moisture forms on outside of
freezer.
Exterior Signal light . . .
automatically warns of any unexpected power
failure
To replace burned out signal light:
1. Unplug power cord from outlet
2. Remove base grille. See page4.
If the signal light is not glowing, immediately
check,
l
for power interruption,
l
the power cord, it may be disconnected from
the outlet,
l
the signal light; it may be burned out
3. Unplug burned out light and replace with one
of same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer, Part No.
530584.
4. Replace base grille. See page 4.
5. Plug power cord into outlet.
3