Whirlpool EVl50NXW Freezer User Manual


 
Important Safety Instructions
To reduce the risk of fire, electrical shock, or injury when using your
freezer, follow basic precautions including the following:
l
Read all instructions before using
It is your responsibility to be sure
the freezer.
your freezer:
l
Child entrapment and suffocation
l
is installed and leveled on a floor that will hold
are not problems of the past. Junked
the weight, and in an area suitable for its size
or abandoned freezers are still
and use.
dangerous...even if they will “just
sit in the garage a few days.”
l
is connected only to the right kind of outlet, with
the right electrical supply and grounding. (Refer
If you are getting rid of your old freezer,
to the Electrical Requirements and Grounding
do it safely. Please read the enclosed
Instructions Sheet.)
safety booklet from the Association of
Home Appliance Manufacturers. Help
l
is used only to do what home freezers are
prevent accidents.
designed to do.
l
is not near an oven, radiator or other heat
l
Never allow children to operate, play
source.
with, or crawl inside the freezer.
l
Never clean freezer parts with flamma-
l
is properly maintained.
ble fluids. The fumes can create a fire
l
is out of the weather.
hazard or explosion.
l
is used in an area where the temperature
l
FOR YOUR SAFETY
l
will not exceed 110°F (43.3”).
DO NOT STORE OR USE GASOLINE OR
l
is not used by anyone unable to operate it
OTHER FLAMMABLE VAPORS AND LIG-
properly.
UIDS IN THE VICINITY OF THIS OR ANY
l
is not loaded with food before it has time to get
OTHER APPLIANCE. THE FUMES CAN
properly cold.
CREATE A FIRE HAZARD OR EXPLOSION.
- SAVE THESE INSTRUCTIONS -
Cleaning Your Freezer
This freezer should be cleaned before you use it.
Also clean when frost has built up to about ‘/4 inch
(6mm) thickness. Complete defrosting and clean-
ing should be done at least once a year. In high
humidity areas, a freezer may need more frequent
defrosting.
Use a sponge, cloth or paper towel and mild
detergent in warm water to clean removable parts
(trivet), outside of freezer, door liner and gasket.
Rinse and then dry.
Waxing painted metal surfaces on outside of
freezer provides rust protection.
NOTE: Do not use wax on plastic parts. Wax may
damage them.
Wash the inside walls with a solution of 2 table-
spoons (26 g) baking soda to 1 quart (.95 L) warm
water. Rinse and then dry.
Personal Injury Hazard
Watch out for sharp wire ends at top of
condenser coils. They can cause injury or
damage brush.
from the wall. Clean dust and lint from condenser
coils behind the freezer, every two or three months.
To clean a freezer needing defrosting, turn Tem-
perature Control to OFF and unplug power cord.
Place a shallow pan (sides no higher than 1 inch)
on floor, centered under drain hole in bottom of
freezer. Place pans of hot water inside freezer with
door open to speed melting. Directing air from an
electric fan into freezer will also help.
Electrical Shock and
Product Damage Hazard
l
Do not place electrical devices in freezer.
Shock or injury can occur.
l
Do not use an ice pick, knife or other
sharp-pointed tool to defrost freezer.
Damage can occur.
l
Do not use abrasive or harsh cleansers on
your freezer. Do not use cleaning waxes,
concentrated detergents, bleaches or
cleansers containing petroleum on plastic
parts. Damage can occur.
To clean condenser coils, use a vacuum cleaner
with brush attachment. Slide freezer out away
Use a plastic scraper to remove frost. Remove
water from walls with towel or sponge. Wash, rinse
and dry as above.