Filter
Top Products
14
TONES
Tones tell you if a function is entered correctly or
not. They also tell you when a cycle is completed.
To shut off all tones except the end-of-timer and
error tones:
Press and hold STOP TIME for 5 seconds. A short
tone will sound to tell you the tones have
been changed. Repeat to turn the tones
back on. You will see “off” for 3 seconds
when the tones are turned off and “on” for
3 seconds when they are turned on.
To choose between high and low volume tones:
Press and hold DELAY START TIME for 5 seconds.
A short tone will sound to tell you the tones
have been changed. Either “HI” or “LO” will
appear on the time display for 3 seconds to
show the volume you chose.
DELAY
START
TIME
STOP
TIME
USING YOUR RANGE
1. Place the racks where you need them. For more
information, see
“Positioning racks and
pans” in “Using the Oven”
earlier in this section.
BAKING/ROASTING
PRESS YOU SEE
BAKE
F
BAKE
PRESS YOU SEE
F
BAKE
(example for bake at 375°F)
TEMP
2. Choose the bake setting.
3. Set the temperature (optional).
Do this step if you want to set a temperature
other than 350°F. Press ▲ to raise the
temperature or ▼ to lower the temperature in
5°F amounts. Use these pads until the desired
temperature shows on the small display.
4. When roasting, put your food in the oven. You
do not have to preheat
the oven when roasting,
unless your recipe
recommends it.
NOTE: The oven will cook
normally even though the
preheat conditioning timer
is displayed.
Roasting meats and poultry
•
For even cooking, place the meat on a rack in a
shallow pan. This keeps the meat out of the
drippings and allows the heat to circulate better.
•
Use a meat thermometer for the most accurate
doneness. Insert it so the tip is in the center of
the largest muscle or thickest portion of the meat
or poultry. Make sure the thermometer is not
touching bone, fat, or the bottom of the pan.
Rear
Front
IMPORTANT: Do not try to light the oven burner
during a power failure. Never place food or
cookware directly on the oven door or the oven
bottom. When using the oven for the first time, it is
necessary to light the surface burners first, to purge
air from the gas lines.