Filter
Top Products
7
To Clean:
1.
Remove the burner cap from the burner base and clean
according to “General Cleaning” section.
2.
Clean the gas tube opening with a damp cloth.
3.
Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.
4.
Replace the burner cap, making sure the alignment pins on
the cap are properly aligned with the burner base.
1. Incorrect
2. Correct
5.
Turn on the burner. If the burner does not light, check cap
alignment. If the burner still does not light, do not service the
sealed burner yourself. Contact a trained repair specialist.
OPEN SURFACE BURNERS (on some models)
Burner ports:
Check burner flames occasionally for proper size
and shape as shown below. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
To Clean:
1.
Remove the surface burner grates.
2.
Lift-up the cooktop. See the “Lift-up Cooktop” section.
3.
Clean clogged burner ports with a straight pin as shown. Do
not enlarge or distort the port. Do not use a wooden
toothpick. If the burner needs to be adjusted, contact a
trained repair specialist.
4.
Close the cooktop.
5.
Replace surface burner grates.
6.
Turn on the burner. If the burner does not light, do not service
the open burner yourself. Contact a trained repair specialist.
Lift-up Cooktop
(on some models)
The lift-up cooktop provides easy access for cleaning beneath.
Be careful not to drop the cooktop. Damage could occur to the
finish and the cooktop frame. For more information, see the
“General Cleaning” section.
To Lift:
1.
Lift up the cooktop by both front corners until the supports
lock into place.
To Replace:
1.
Lift the cooktop from both sides while pressing the support
rods back to unlock them.
2.
Slowly lower the cooktop into place.
1
2
1
2
"
Ports