Filter
Top Products
Using DELAY START
4. Close and latch the door.
1. Push desired Cycle Selector Button.
NOTES:
2. Push desired Option Selector Button(s).
l
You can add items while time is counting
3. Turn Control Knob clockwise to the number of
down. Close and latch the door. The timer will
hours (from 1 to 4 hours) you want the dish-
not advance if the door is unlatched.
washer to delay before the selected cycle
starts.
l
RINSE & HOLD and LOW ENERGY WASH Cycles
cannot be delayed.
Changing a setting
You can change a setting anytime during
2. Turn the Cycle Control Knob clockwise to the
any cycle.
cycle you want.
1. Lift up on the door latch to stop the cycle. 3. Be sure the detergent dispensers are filled
Don’t open the door until the spray arms stop properly for the new cycle.
spinning.
4. Press door firmly to latch it. The dishwasher
will automatically start the new cycle.
The CLEAN Signal Light
The CLEAN Signal Light will come on when a
To turn light off, turn the Control Knob clock-
washing cycle is complete.
wise slightly until the light goes off.
To add a dish after starting
3. Open the door and add the dish.
1. To be sure the added item is washed and
4. Close the door. Do not latch it. Wait 30 sec-
rinsed, make sure the Cycle Control Knob
onds for air in the dishwasher to warm up. This
has not passed LOW ENERGY WASH.
helps reduce the amount of moisture that
2. Lift up on the door latch to stop the cycle.
can come from the vent when restarting the
Don’t open the door until the spray arm stops
cycle.
spinning.
5. Press door firmly to latch it. The dishwasher
will start from where it stopped.
10