Whirlpool GR475LXL Range User Manual


 
19
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
Before Removing:
1.
Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
2.
Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3.
Repeat procedure for other door stop clip.
To Remove:
1.
Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
2.
Carefully close the door until it rests against the door removal
pins.
3.
Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4.
Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
To Replace:
1.
Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
2.
Hold oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
slots.
3.
Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
4.
Insert the door stop clip with the angular surface at the top of
the frame hinge slot, then push in the bottom of the clip until
flanges are flush with the front frame.
5.
Open the door completely and remove the door removal pins.
Save door removal pins for future use.
6.
Close the door.
Storage Drawer
The storage drawer can be removed. Before removing, make sure
drawer is cool and empty.
To Remove:
1.
Pull drawer straight out to the first stop.
2.
Lift up the back of the drawer and pull out.
To Replace:
1.
Fit the ends of the drawer rails into the guides in the cavity.
2.
Slide the drawer closed.
Warming Drawer
(on some models)
Remove all items from inside the warming drawer, and allow the
unit to cool completely before attempting to remove the drawer.
To Remove:
1.
Open drawer to its full open position.
2.
Locate the black triangle-shaped tabs on both sides of the
drawer.
1. Tab
3.
Press the tab down on the right side, and lift tab up on the left
side at the same time, then pull drawer out another inch.
4.
Holding the drawer by its sides, not its front, carefully pull it
all the way out.
To Replace:
1.
Align the drawer glides with the receiving guides.
2.
Push drawer in all the way.
3.
Gently open and close the drawer to ensure it is seated
properly on the slides.
1