Filter
Top Products
14
2. Using twist-on connectors sized to connect power supply
cord to 16-gauge dishwasher wire, connect the white wire
from the power supply cord to the white wire on the terminal
box.
3. Using twist-on connectors sized to connect power supply
cord to 16-gauge dishwasher wire, connect the black wire
from the power supply cord to the black wire on the terminal
box.
4. Using twist-on connectors sized to connect power supply
cord to 16-gauge dishwasher wire, connect the ground wire
from the power supply cord to the green ground connector on
the terminal box.
5. Reinstall the terminal box cover with the wires inside terminal
box.
6. Check that no wires are pinched by the cover.
7. Plug power supply cord into a grounded 3 prong outlet.
8. Check that the power supply cord does not touch the
dishwasher motor or lower part of dishwasher tub.
Connect Dishwasher to Water Supply
1. Route the water supply line so that it does not touch the
dishwasher base, frame or motor.
2. Slide the nut onto the copper tubing about 1" (2.5 cm).
3. Slide the ferrule onto the tubing.
NOTE: Do not position ferrule on the end of the tubing.
4. Push the tubing into the elbow as far as it will go.
5. Slide the nut and ferrule forward and start the nut onto the
elbow threads. Avoid bending or kinking the copper tubing.
6. With the copper tubing pushed into the compression fitting as
far as it will go, use a wrench and tighten the compression
fitting nut to elbow on water inlet valve.
NOTE: Do not use Teflon
®
tape with compression fittings.
7. Place paper towel under the elbow.
8. Turn on the water supply.
9. Check for leaks.
Connect Dishwasher to Drain
1. Route the drain hose so that it does not touch the dishwasher
motor, door springs, water line, cabinet, flooring or the edge of
the hole where it passes through the cabinet.
NOTE: Do not remove the drain loop from the side of the
dishwasher.
2. Place the shallow pan under the end of the drain hose. The
pan will collect any water in the drain hose.
3. Cut on the molded end of the drain hose to fit 1" (2.5 cm), ³⁄₄"
(1.9 cm) or ⁵⁄₈" (1.6 cm) diameter connections on the air gap,
waste tee or waste disposal.
4. If a longer drain hose is required, add up to 42" (107 cm) of
length for a total of 10 ft (3 m) to the factory-installed drain
hose.
NOTE: Total drain hose length must not exceed 10 ft (3 m) for
proper drain operation.
A. White wire to white wire
B. Ground wires to green ground connector
C. Grounding screw
D.Black wire to black wire
A. Elbow
B. Ferrule
C. Nut
A
B
C
D
A
B
C
A. Water inlet valve
B.Elbow
A. Drain hose
A. Cutting lines
®Teflon is a registered trademark of E.I. Dupont de Nemours and
Company.
A
B
A
1"
3/4"
5/8"
A