Filter
Top Products
Number Pads
Fan and Light Pads
control the P-Speed Exhaust Fan and the Cook-
top Light.
Touch Fan Pad for the desired fan speed.
(NOTE: If the temperature gets too hot around
the mlcrowave oven, the exhaust tan In the
Once you’ve touched a Command Pad to tell
the oven what you want It to do, you’ll touch
vent hood will automatically turn on or
change to the HIGH sefflng to protect the
oven. lt may stay on up to an hour to cool the
Number Pads to tell it...
-a time.
-a Cook Power.
oven. When this occurs, the Fan Pad will not
turn the tan off.)
Touch Light Pad for the desired cook-top or
countertop lighting.
Audible Signals
Audlble signals are avallable to guide you when setting and using your oven. (A programmlng tone will
sound each ttme you touch a pad. Two beeps will sound between cycles. A remtnder tone will sound every
60 seconds after cooklng Is done to remind you that something has been left in the oven. 4 beeps slgnal
the end of the Minute Tlmer fun&ton.) If you don’t hear a tone, It Is because of incorrectly entered Instructions
or because the tones have been removed. For example, a tone will not sound If you touch a Number Pad
before you touch a Command Pad.
To remove the programmlng tone and
reminder tone:
l
Open the door.
l
Touch CLEAR
twice,
then touch START.
l
Programmlng and remlnder tones will
be cancelled.
To replace the tones:
l
Repeat the steps above.
To remove all tones:
l
Open the door.
l
Touch CLEAR
twice,
touch 0, then touch START.
l
All audible tones (including Mlnute Timer
signal) will be cancelled.
NOTE: Do not remove all tones If you use the
Minute Timer.
To replace the tones:
l
Repeat the steps above.
NOTE: It your electrlclty goes off, the tones will be replaced when the electrlclty comes back on.
Setting the Clock
When the oven Is first plugged in, a tone sounds and the Display shows “88:881’ If the
electric power ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook or use the Minute Timer without setting the Clock, but the Display will be
blank after cooklng.
DO THIS...
THIS HAPPENS...
F!!!
1. Touch
CLOCK.
The Display will show a “0” and the
colon will start to flash. The flrsl
Number Pad must be touched wlthln
5 seconds or the Display will go
blank.
If this happens, touch CLOCK
again and continue.
6