Filter
Top Products
Building in your microwave oven
Your microwave oven is not limited to carts, counters or tables. Custom installations are made
easy with kits available from your dealer.
1.
Build the microwave oven into a cabinet or
wall by itself or over built-in single ovens in the
Whirlpool RDE, REE, RGE, RB and SB model series.
2. Attach the microwave oven to a wall by itself
or with cabinets over It.
3. Put the microwave oven on the MICRO SHELFo
Hood over a cooktop. The hood is available
ducted or as a recirculating hood, and includes
cooktop lights.
Ask your dealer for details on...
l
832978 -30-inch Built-in Kit
l
832989 - 24-inch Built-in Kit
l
832991 -27-inch Built-in Kit
l
832993 -Wall Mounting Kit
l
RH3330XR - MICRO SHELFn Hood
Use only approved installation kits.
Obtain these kits from your authorized
Whirlpool dealer.
Caring for your microwave oven
Cleaning the microwave oven
Wipe often with warm sudsv
water and a soft cloth or
sponge
For stubborn soil, boil a cup
of water In the oven for 2 or 3
minutes Steam
will
soften
the so11
Be sure to cleG the areas
where the door and oven
frame touch when closed.
When cleaning surfaces of
door and oven that come to-
gether on closing the door,
use only mild, non-abrasive
soaps or detergents applied
with a sponge or soft cloth.
Rinse well
Caution:
Abrasive cleansers, steel wool pads, gritty wash cloths, etc., can damage the control
panel, electronics, and the interior and exterior oven surfaces. Use a soft cloth or a
sponge with a mild detergent or spray glass cleaner.
Replacing the light bulb
The microwave oven light should come on whenever the door is opened or the oven is operating
To replace:
1.
Unplug, or turn off at fuse box or circuit
breaker.
2.
Open the oven door.
3. Remove the 3 screws from the front of the
cover.
4. Pull down the front portion of the cover.
[;zgcrfased across its width to form a
5. Remove and replace the 25watt candelabra-
base bulb (FSP 313760). Obtain bulb from
yourauthorized Whirlpool dealer.
6.
Close the cover and replace the screws
7. Plug in, or turn on the main power supply