Filter
Top Products
Audible signals
Audlble signals are available to guide you when setting and using your oven. (A programming tone will
sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound
every 30 seconds after cooking is done to remind you that something has been left in the oven. A
4 second tone signals the end of the Minute Timer function.) If you don’t hear a tone, it is because of
lnCOmdiy entered instructions or because the tones have been removed. For example, a tone will not
sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone:
To remove all tones:
l Open the door.
l Open the door.
l Touch CANCEL twice, then touch START.
l Touch CANCEL twice, touch 0, then touch START.
l Programmlng and reminder tones will be
l All audible tones (including minute timer sig-
cancelled.
nal) will be cancelled.
NOTE: Do not remove ail tones if YOU use the
To replace the tones:
l Repeat the steps above.
Minute Timer.
To replace the tones:
l Repeat the steps above.
NOTE: if your eiectrlcity goes off, the audible signals will come back on. Repeat steps
above if you want to remove them again.
Setting the clock
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric
power ever goes off, the Clock/Display will again show all 8’s when the power
comes bock on.
You can cook or use the Minute Timer without setting the clock, but the display
will be blank after cooking.
DO THIS...
THIS HAPPENS...
The Display will show a “0” and
the colon will start to flash. The
first Number Pad must be touched
withln 5 seconds or the Display will
go blank. Touch CLOCK SET again
and continue.
2. Touch Number Pads for the
correct ttme of day.
The Display will show what numbers
you touched in the order you
touched them. This example shows
3:25.
The colon will stop flashing. The Clock
IS set.
If you have touched in an incorrect
time, such as1265 “Err” will show on
the Display. Touch CLOCK SET and
start over.
NOTE: To reset the clock, touch CLOCK SET. The current ttme will show on the Display and
the colon will flash. Continue to set the clock as shown above.
6