Filter
Top Products
3. Pull the surface unit straight away
from the receptacle.
4. Lift out the reflector bowl. See
“Cleaning Char-t” on page 9 for
cleaning instructions.
Replacing
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
2. Line up openings in the reflector
bowl with the surface unit recep-
tacle and the element hold down
clip.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.