Filter
Top Products
Replacing
1.
Be sure coil elements are OFF.
2. Line up opening in the reflector bowl with the
coil element receptacle.
3. Hold the coil element as level as possible
with the terminal just started into the
receptacle.
Reflector bowls reflect heat back to the
utensils on the coil elements. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a reflector bowl gets discolored, some of
the utensils used may not be flat enough. Or
some may be too large for the coil element.
In either case, some of the heat that is meant
to go into or around a utensil goes down
and heats the reflector bowl. This extra heat
can discolor it.
Solid elements
4. While pushing the coil element terminal into
the receptacle, lift a little on the edge of the
unit nearest the receptacle.
5. When the terminal is pushed into the recep-
tacle as far as it will go, the coil element will
fit into the reflector bowl.
Solid elements are not removable. After
each use, wipe off the elements with a damp,
soft cloth and soapy water. Burned-on food
may be removed with a soapy scouring pad.
The red spot in the center of the elements will
gradually wash off. This is normal and will
not affect the operation of the elements.
IMPORTANT: AFTER EACH CLEANING, HEAT ELEMENTS UNTIL DRY.
To darken elements or to remove rust spots caused by improper drying, apply
a thin coat of salt-free oil to the CCCL elements, then heat for 3-5 minutes. If
elements have dark spots, the oil treatment will improve their appearance but
will not eliminate the spots.
The stainless steel spillrings will gradually yellow from the heat of the elements
and pans. This is normal. The yellowing can be removed by using stainless
steel cleaner on the spillrings.
16