Filter
Top Products
3. Pull the surface unit straight away
from the receptacle.
Replacing
1.
4. Lift out the reflector bowl. See
Cleanlng Chart on page 17 for
cleaning instructions.
2. Hold the surface unit as level as
possible with the terminal just
started into the receptacle.
Push the surface unit terminal into
the receptacle. When the terminal
is pushed into the receptacle as
far as it will go, the surface unit will
fit into the reflector bowl.
Line up opening in the reflector
bowl with the surface unit
receptacle.
CAUTION: Reflector bowls reflect heat back to the utenslb on the
surface units. They also help catch splits. When they am kept clean,
they reflect heat better and look new longer.
If a reflector bowl gets dlscolored, some of the utensils may not be
flat enough, or some may be too large for the surface unit. In either
case, some of the heat that’s meant to go Into or around a utensil
goes down and heats the rettectof bowl. lhls exim heat can dlsoolor
lt. See WookIng Guide” for further Informatton.