Filter
Top Products
PROBLEM
POSSIBLE CAUSE
SOLUTION
Self-Cleaning
The Oven Selector and Oven
Set both the Oven Selector and Oven
cycle will not Temperature Control Knob
Temperature Control Knob to CLEAN.
operate are not set to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day.
of day. (See page 12.)
The Lock Lever is not in the
Move Lock Lever all the way to the
CLEAN positio~ll the way
right.
to the right.
A delayed start time has been
Wait for the start time to be reached.
programmed.
Cooking
The range is not level.
Level range. (See Installation Instruc-
results are not
tions.)
what you
expected
The oven temperature is too
See page 15 for instructions on how
low or too high.
to adjust the Oven Temperature
Control.
The oven was not preheated
Preheat oven when called for in
before baking.
recipe.
The recipe has never been
Use only tested recipes from a
tested or is not from a reliable
reliable source.
source.
The pan used is not the type
or size recommended in the
recipe.
There is not proper air
circulation around pan when
baking.
Cooking utensil does not fit
the surface unit being used.
Refer to a reliable cookbook for
recommended pan type and size.
Allow 1% to 2 inches (4-5 cm) of air
space on all sides of pan. There must
be a minimum space of 1 inch
(2.5 cm).
Pan shoukf be the same size or
slightly larger than surface unit being
used.
The display is There has been a power
Reset the clock. (See page 12.)
flashing
failure.
‘88:88”
“F2” shows in
Call for service. (See Step 3 on
the display
paw 43.1
42