Filter
Top Products
Replacing
Burn, Electrical Shock and Fire Hazard
l
Make sure all surface units are OFF before replacing surface units and
reflector bowls. Failure to do so can result in burns or electrical shock.
l
Do not line the reflector bowls with foil. Fire or electrical shock
could result.
1.
Turn off CIII surface units.
3. Hold the surface unit as level as
possible with the terminal just
started into the receptacle. Push
the surface unit terminal into the
receptacle.
2. Line up openings in the reflector
bowl and notch in the trim ring
with the surface unit receptacle
and the element hold down clip.
4. When terminal is pushed into the
receptacle as far as it will go, push
down the edge of the surface unit
opposite the receptacle. The ele-
ment hold down clip will keep the
surface unit from moving around.
NOTE: Reflector bowls reflect heat back to the utensils on the surface
units. They also help catch spills. When they are kept clean, they reflect
heat better and look new longer.
If a trlm ring gets discolored, some of the utensils may not be flat enough,
or some may be too large for the surface unit. In either case, some of the
heat that’s meant to go into or around a utensil goes down and heats the
trim ring. Thls extra heat can discolor it. See Cooking Guide for further
information.
21