Filter
Top Products
2. Loosen the locking screws inside the control
knob. Note the position of the notches.
3. To lower the temperature, hokf knob handle
firmly and move the tooth a notch counter-
clockwise. Each notch equals about 5°F
(2.5%).
4. To raise the temperature, hold knob handle
firmly and move the tooth a notch clockwise.
Each notch equals about 5’F (2.5%).
5. Tighten the locking screws and replace the
control knob.
Locking
Tooth
Broiling
1. Position the rack properly before turning on
the oven. Position rack so that the surface of
the food is at least 3 inches (7 cm) away from
the broil element. See “Broiling rack position
chart” on page 14.
2. Put the broiler pan and food on the rack
3. Close the door to the Broil Stop position (open
about 4 inches
[lo
cm]). The door will stay
open by itseff.
4. Set the Oven Selector and Oven Temperature
Control to BROIL. The OVEN HEATING
Indicator Light will come on.
NOTE: Do not preheat oven when broiling.
5. When broiling is done, turn both the Oven
Selector and Oven Temperature Control to
OFF. The OVEN HEATING Indicator Light will
go off.
Custom
broil
l
tl food is cooking too fast, turn the Oven
Temperature Control counterclockwise until the
OVEN HEATING Indicator Light goes off.
l
If you want the food to broil slower from the start,
set the Oven Temperature Control Knob between
170°F and 325°F (77°C and 163°C). These
temperature settings allow the broil heating
element to cycle and to slow cooking. The lower
the temperature, the slower the cooking.
l
Fish and chicken are some foods that may cook
better if you use lower broiling temperatures.
The Oven Selector must be on BROIL for all
broiling temperatures.
NOTE: Leave the oven door partly open when-
ever using the oven to broil. This allows the oven
to maintain proper temperatures.
13