6
Start
The START pad begins any function. If it is not touched within
5 seconds after touching a pad, “PRESS START” will scroll in the
display as a reminder. If START pad is not touched within
2 minutes after touching a pad, the display will return to the time
of day mode and the programmed function will be canceled.
If cooking is interrupted by opening the door, touching START will
resume the preset cycle.
Off Cancel
The OFF CANCEL pad stops most functions except for the
Control Lock and Demo Mode.
The microwave oven will also turn off when the door is opened.
Close the door and touch START to resume the cycle.
Add 1 Minute
The ADD 1 MINUTE control automatically starts the microwave
oven at 100% power for 1 minute, and adds 1 minute of cook
time, up to 10 minutes, with each additional touch of the control.
Touching ADD 1 MINUTE during a manual cook cycle will add
1 minute of cook time at the current cook power.
Clock
This is a standard 12-hour clock (12:00-11:59) and does not
show a.m. or p.m.
To Set:
The microwave oven and timer must be off.
1. Touch CLOCK.
2. Touch the number pads to set the time of day.
3. Touch CLOCK or START.
To Remove:
1. Touch CLOCK.
2. Touch 0.
3. Touch CLOCK.
The time will disappear, and “:” will appear on the display.
Tones
Tones are audible signals, indicating the following:
One tone
■ Valid entry (short tone)
■ End of timer countdown
Two tones
■ End of stage in multistage cooking
■ Control Lock active
■ Hidden feature has been entered or exited
■ Reminder, repeat each minute after the end-of-cycle tones
Three tones
■ Invalid entry
Four tones
■ End of cycle
To Turn Off/On Valid Entry Tones: With the microwave oven in
standby mode, touch and hold the number pad “1” for 3 seconds
until 2 tones sound. Touch and hold number pad “1” to turn tones
back on.
To Turn Off All Tones (except end-of-timer and hidden feature
tones): With the microwave oven in standby mode, touch and
hold the number pad “2” for 3 seconds until 2 tones sound.
Touch and hold number pad “2” to turn tones back on.
Timer
The Timer can be set in minutes and seconds, up to 90 minutes,
and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
While the Timer is in use, the microwave oven can also operate.
To see the countdown for 10 seconds while the microwave oven
is in use, touch TIMER SET/OFF.
To Set:
1. Touch TIMER SET/OFF.
The TIMER icon will appear in the display.
“ENTER TIME IN MIN AND SEC” will scroll in the display. If no
action is taken after 2 minutes, the display will return to the
time of day mode.
2. Touch the number pads to set the length of time.
3. Touch TIMER SET/OFF or START.
When the set time ends, “END TIMER” will appear in the
display, and the end-of-timer tone will sound, followed by
reminder tones.
Remember, touching OFF CANCEL while a cook function is
active in the display will cancel the cook function, not the
Timer.
4. Touch TIMER SET/OFF or OFF CANCEL to cancel the Timer
when only the Timer is operating.
Touch TIMER SET/OFF when a cook function is also
operating to make the Timer countdown active in the display,
and then touch OFF CANCEL to cancel the Timer. The cook
function will continue to operate.
Control Lock
The Control Lock shuts down the control panel pads to avoid
unintended use of the microwave oven.
When the control is locked, only the Vent Fan and Light pads will
function. If any other control pad is touched, “LOCKED” will
appear in the display and the invalid entry tones will sound.
To Lock/Unlock Control: The microwave oven must be in
standby mode. Touch and hold OFF CANCEL for 3 seconds until
2 tones sound and a padlock icon appears in the display. Repeat
to unlock and remove the padlock icon from display.