Filter
Top Products
9
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the
“Installation Instructions” for more information.
WATER INLET HOSES
Washer Maintenance
Wash Temp Suggested Fabrics
8. Select WASH TEMP
Once you select a cycle, select the wash temperature by
turning the Wash Temp knob to the desired setting.
Always read and follow fabric care label instructions to
avoid damage to your items.
9. Select cycle options, if desired
If you would like to add an extra rinse or presoak period to
any cycle, turn the knob to desired setting.
10. Press START/Pause
to begin wash cycle
Press the START/Pause button to start the wash cycle. When
the cycle has nished, the DONE indicator will light. Promptly
remove items after cycle has completed to avoid odor, reduce
wrinkling, and rusting of metal hooks, zippers, and snaps.
Adding garment(s)
During the Fill/Sensing phase, open lid and add 1 or 2 missed
garments. Then close lid and press START/Pause to restart
the cycle. If you need to open the lid to add a garment after
this point, you must press START/Pause and wait for the
lid to unlock. This may take several minutes if the load was
spinning at a high speed. You may hear a winding sound as
the basket slows down. Then add garment, close lid, and
press START/Pause again to resume the cycle.
NOTES:
■ Washer will ll with the lid open.
■ If your washer does not have a soak option, then pause
your washer to soak. When you are done soaking then
press Start/Pause button to bring washer out of Pause.
IMPORTANT: If lid is left open for more than 10 minutes, the
water will pump out automatically.
Cool
Warm water is added to assist in
soil removal and to help dissolve
detergents. Cool is slightly warmer
than cold.
Dark colors that
bleed or fade
Light soils
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cold
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Whites and pastels
Durable items
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
Tap Cold
This is the temperature from your
faucet.
7. Select SOIL LEVEL
Once you select a cycle, select the soil level by turning the
Soil Level knob to the desired setting.