Filter
Top Products
13
1. Determine the cartridge
installation location on the wall
under the sink. The mounting
template is to help you to locate
the mounting bracket. Keep in
mind that the center of the top
holes on the mounting template
must be at least 14’’ (35.6 cm)
from the bottom of the under
sink cabinet. Position the
mounting template securely with
tape. Once template is level, drill
the guide holes.
NOTE: Be careful not to drill
into plumbing or wiring inside
the wall.
A
unit
B
unit
C
unit
14”
2. Using 2 Phillips head screws
provided, mount 1 bracket to
wall (position on left for Unit A).
3. Mount Unit B mounting bracket
to wall, to the immediate right
of Unit A bracket. The brackets
should interlock with each
other.
Tabs must be
located at the bottom.
8
Standard or tall neck faucet
Parts Supplied
1. Faucet
2. 8 feet of white tubing
3. 1 rubber washer
4. 1 metal retaining bracket
5. 1 retaining nut
6. 1 threaded rod
7. 4 Phillips screw
8. ‘’T’’ water line connector
9. Flow monitor indicator ring
and switch
10. Flow monitor
11. 2 AA batteries
12. Cap
13. 2 wall mounting clips
1or
2
8
9
10
11
12
3
4
5
6
7
Install the Filterhead Valve
and Filter Cartridge
4. Press filterhead valve firmly
against the top of the mounting
bracket.
Pressing firmly, slowly slide the
filterhead valve downwards until
both the top and bottom tabs
are secure.
Slide the filterhead valve to the
center of the mounting bracket.
(You should hear a slight click
when filterhead valve is secure).
Click
1
2
3
5. Make sure filterhead valve
is open by pulling up on the
center front.
model WHAB-6014 model WHAB-6012
model WHAB-6015 model WHAB-6013