Filter
Top Products
PROBLEM
Small particles deposited on items
(continued)
Dishes not dry
Black marks on dishes
Chipping or breaking glassware
Dishes not washing clean
CAUSED BY
“Old” detergent
Not enough cleteigent. or nnpropei
detergent
Water 1s not hot enough
Water pressure may be low.
dishwasher IS not fillmg properly
No rinse agent
Water IS not hot enough
Improper loading
Drying without heat
Aluminum utensils rubbing against
items during washmg
Improper loading
Water is not hot enough
Improper loading
r
SOLUTION
Use only fresh dishwasher cletergent
Store tightly closed container m cool.
dry place. Discard old detergent Do
not fill dispensers until ready to start
drshwasher.
Use more drshwasher deter-gent. Use
detergent with highest available
phosphorus content
especially with
hard water
Water tempeiature should be at least
140 F (60 C) Set water heater
thermostat to a higher setting. Run
water at smk untrl hot before starting.
If water pressure is low, do not use
water for other purposes whrle
dishwasher is running (to assure
correct fills).
Does the rmse agent dispenser need
filling7 See instructions on page 5.
Water temperature should be at least
140 F (60 C). Set water heater
thermostat to a higher setting. Run
water at smk until hot before startmg.
Make sure dishes and glassware are
loaded so spray reaches all surfaces
and items dram properly. Do not
overload. Do not nest items
Allow more time when drymg without
heat, or dry with heat. Plastic items
may need towel drying.
Use care m loading aluminum utensils,
especially any lightweight foil
container. Place so they do not touch
dishes. Remove black marks with
plastic scourmg pad and a mild
abrasive cleanser.
Do not overload. Load glasses m the
top rack only. Load between prongs,
not over them. Glasses loaded over
prongs will not be supported and may
chip or break.
Water temperature should be at least
140-F (60 C). Set water heater
thermostat to a higher setting. Run
water at sink until hot before starting.
Make sure dishes and glassware are
loaded so spray reaches all surfaces
and items dram properly. Do not
overload. Do not nest items.
Make sure large items do not block
spray from reaching detergent
dispensers.
Page 8