Filter
Top Products
Page 15
Mounting Flange Pieces
There are four individual pieces located in Kit 2 of your enclosed accessory kits. These ange pieces are de-
signed to be used on the backside of the Extreme Series to mount to the exterior wall. There are three punch-
outs located on the exterior of the housing. The punch-outs are designed for specic through-the-wall installa-
tion mounts. Please refer to the illustration for location of the punch-outs.
#1. Retrot your current WhisperKOOL
cooling unit
#2. Middle wall installation
#3. Flush mount to exterior wall
THROUGH-THE-WALL INSTALLATION (without ductwork)
Applying Insulation Tape
Locate the four precut pieces of
black foam tape included with the
system. There should be two larger
pieces and two smaller pieces. Once
you have attached the ange pieces
to the unit, peel back the white-
paper adhesive covering and place
on the corresponding size of ange.
The large pieces are applied to the
top and bottom of the unit and the
smaller pieces to the right and left
side anges. This foam creates a
tight seal between the ange and
the wall.
Front of unit
Back of unit