Filter
Top Products
6
INSTALLATION
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your upright freezer
Remove tape and glue from your upright freezer before using
To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to
remove tape or glue. These products can damage the surface of your upright freezer.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your upright freezer before using it.
See the "Usage Tips" in the Cleaning and Maintenance section.
INSTALLATION CLEARANCES
Your freezer should be conveniently located for day-to-day use in a dry, well-ventilated room. Do not
install the freezer where the temperature will go below 50°F or above 90°F, because it will not maintain
proper temperatures. Be sure to install your freezer on a floor strong enough to support it when it is fully
loaded.
Free-standing installation
A free-standing installation will allow you to install the upright freezer in any place you desire provided
that the required clearance space around the appliance is respected. In every setting, there must be
Excessive Weight Hazard
Two or more people should move and install upright freezer. Failure to do so can result in back or other
injury.