Filter
Top Products
¾ EXTENSION CORD
IT IS STRONGLY RECOMMENDED THAT YOU DO NOT USE AN EXTENSION CORD WITH THIS
APPLIANCE. HOWEVER, IF YOU MUST USE AN EXTENSION CORD IT IS ABSOLUTELY
NECESSARY THAT IT BE A UL/CUL-LISTED, 3-WIRE GROUNDING TYPE APPLIANCE
EXTENSION CORD HAVING A GROUNDING TYPE PLUG AND OUTLET AND THAT THE
ELECTRICAL RATING OF THE CORD BE 115 VOLTS AND AT LEAST 10 AMPERES.
¾ CONNECTING
THE WATER SUPPLY
• ALL
THE REQUIRED OR CUSTOMIZED HARDWARE IS NOT PROVIDED FOR INSTALLATION
SO IT IS NECESSARY TO HIRE A PROFESSIONAL LICENSED PLUMBER TO COMPLETE THE
INSTALLATION.
• CONNECT
TUBING (SUPPLIED WITH UNIT) TO THE NEAREST COLD WATER SOURCE.
CONNECT SUFFICIENT TUBING TO THE UNIT TO ALLOW THE APPLIANCE TO BE MOVED
FREELY FOR CLEANING AND SERVICE. ALSO, MAKE SURE THAT THE TUBING IS NOT
CRIMPED OR DAMAGED DURING TRANSPORTATION.
• POSITION
UNIT TO ALLOW FREE AIRFLOW THROUGH THE FRONT GRILL (SEE SKETCH 1).
• WIPE
INSIDE OF UNIT AND ICE BUCKET WITH A DAMP CLOTH.
OPERATING YOUR ICE MAKER
¾ INITIAL START-UP OPERATION
1. PLUG THE APPLIANCE INTO A 115/120V POLARIZED AND GROUNDED WALL ELECTRICAL
OUTLET.
2. PLACE
THE ON-OFF SWITCH IN THE “ON” POSITION.
3. MAKE
SURE THE WATER SUPPLY IS ON. AS SOON AS THE INNER MECHANISM REACHES
THE PROPER TEMPERATURE, THE ICEMAKER MECHANISM WILL FILL THE MOLD WITH
WATER.
4. THE
FIRST CUBES MAY BE SMALL BECAUSE OF AIR IN THE WATER LINE. LATER CUBES
WILL BE OF STANDARD CRESCENT TYPE SIZE.
5. APPROXIMATE
TIME FOR THE FIRST CYCLE IS BETWEEN 30-40 MINUTES.
6. EACH
CYCLE APPROXIMATELY WILL TAKE 5 OZS OF WATER SO YOU SHOULD HAVE A FULL
TRAY, AFTER 11 HOURS.
IMPORTANT:
THROW AWAY ALL ICE CUBES MADE DURING THE FIRST 3 HOURS OF
OPERATION.
• WHEN
THE ICE BUCKET IS FULL, THE ICE MAKING MECHANISM WILL
AUTOMATICALLY SHUT OFF. WHEN ICE CUBES ARE MELTED, THE ICE
MAKING MECHANISM WILL START AGAIN .
• ICE
DELIVERY MAY BE INTERRUPTED BY RAISING THE METAL ARM INTO
AN UPRIGHT POSITION (SEE SKETCH 2)
• IF
THE ICEMAKER IS NOT USED REGULARLY, IT IS RECOMMENDED THAT
THE ICE BUCKET BE EMPTIED PERIODICALLY TO INSURE FRESH ICE.
SKETCH 1
SKETCH 2
aWARNINGa
IMPROPER WATER LINE CONNECTION MAY RESULT IN FLOODING
YOU MUST USE A LICENSED PLUMBER AND
REVIEW STATE AND LOCAL PLUMBING CODES BEFORE INSTALLATION