Whynter UIM-155 Ice Maker User Manual


 
CAUTION
FAILURE
TO UNPLUG THE ICE MAKER DURING MAINTENANCE COULD RESULT IN
ELECTRICAL SHOCK OR PERSONAL INJURY.
¾ POWER FAILURE
TYPICALLY
MOST POWER OUTAGES LAST FOR NO LONGER THAN A FEW HOURS AND SHOULD
NOT AFFECT THE TEMPERATURE OF YOUR ICE MAKER IF YOU MINIMIZE THE NUMBER OF
TIMES THE DOOR IS OPENED. IF THE POWER IS GOING TO BE OFF FOR A LONGER PERIOD OF
TIME, YOU NEED TO TAKE THE PROPER STEPS TO DISCONNECT YOUR APPLIANCE.
¾ VACATION TIME/STORAGE
1. SHUT
OFF WATER SUPPLY AT THE MAIN WATER VALVE.
2. DISCONNECT
THE WATER SUPPLY LINE FROM VALVE.
3. ALLOW
UNIT TO RUN FOR AN HOUR OR TWO UNTIL ALL REMAINING ICE CUBES HAVE
BEEN EJECTED.
4. DISCONNECT
UNIT FROM MAIN POWER SOURCE.
5. DRY
OUT EXCESS WATER FROM ICE MAKER ASSEMBLY
6. LEAVE
THE DOOR AT LEAST TWO INCHES OPEN.
¾ MOVING YOUR ICE MAKER
SECURELY
TAPE DOWN ALL LOOSE ITEMS INSIDE YOUR ICE MAKER.
TURN
THE LEVELING SCREWS UP SECURELY TOWARDS THE BASE OF THE UNIT TO AVOID
DAMAGE.
TAPE
THE DOOR SHUT.
BE
SURE THE ICE MAKER STAYS IN AN UPRIGHT POSITION DURING TRANSPORTATION.
¾ ENERGY SAVING TIPS
THE
ICE MAKER SHOULD BE SITUATED IN THE COOLEST AREA OF THE ROOM, AWAY
FROM HEAT GENERATING APPLIANCES OR HEATING DUCTS, AND OUT OF THE DIRECT
SUNLIGHT.