Filter
Top Products
1
FF
FF
F
INDIND
INDIND
IND
OUTOUT
OUTOUT
OUT
MOREMORE
MOREMORE
MORE
ONON
ONON
ON
THETHE
THETHE
THE
WEBWEB
WEBWEB
WEB
..
..
.
WILBURWILBUR
WILBURWILBUR
WILBUR
CURCUR
CURCUR
CUR
TIS.COMTIS.COM
TIS.COMTIS.COM
TIS.COM
Models Included
••
••
• D500GT
••
••
• D500GT/H
CAUTION: CAUTION:
CAUTION: CAUTION:
CAUTION: DO NOT
connect this brewer to
hot water. The inlet valve
is not rated for hot water.
CAUTION: CAUTION:
CAUTION: CAUTION:
CAUTION: Please use
this setup procedure
before attempting to use
this brewer. Failure to follow the
instructions can result in injury or
the voiding of the warranty.
ISO 9001 REGISTERED
C
WARNING HOT LIQUID,
Scalding may occur.
Avoid splashing.
Important Safeguards/Conventions
D500 Generation 3 - Airpot Brewer Instructions
FOR THE LATEST SPECIFICATIONS AND INFORMATION GO TO
WWW.WILBURCURTIS.COM
This appliance is designed for commercial use. Any servicing other than cleaning and maintenance
should be performed by an authorized Wilbur Curtis service center.
• Do NOT immerse the unit in water or any other liquid
• To reduce the risk of fire or electric shock, do NOT open top or rear panel. No user serviceable parts inside. Repair should
be done only by authorized service personnel.
• Keep hands and other items away from hot parts of unit during operation.
• Never clean with scouring powders, bleach or harsh implements.
ConventionsConventions
ConventionsConventions
Conventions
WW
WW
W
ARNINGS – ARNINGS –
ARNINGS – ARNINGS –
ARNINGS –
TT
TT
T
o help ao help a
o help ao help a
o help a
void personal injurvoid personal injur
void personal injurvoid personal injur
void personal injur
yy
yy
y
Important Notes/Cautions – from the factoryImportant Notes/Cautions – from the factory
Important Notes/Cautions – from the factoryImportant Notes/Cautions – from the factory
Important Notes/Cautions – from the factory
Sanitation RequirementsSanitation Requirements
Sanitation RequirementsSanitation Requirements
Sanitation Requirements
YY
YY
Y
our Curtis our Curtis
our Curtis our Curtis
our Curtis
ADS System is FADS System is F
ADS System is FADS System is F
ADS System is F
actoractor
actoractor
actor
y Pre-Set and Ready Pre-Set and Read
y Pre-Set and Ready Pre-Set and Read
y Pre-Set and Read
y to Go… Right out of the Carton.y to Go… Right out of the Carton.
y to Go… Right out of the Carton.y to Go… Right out of the Carton.
y to Go… Right out of the Carton.
Following are the Factory Settings for your D500GT Airpot Coffee Brewing System:
• Brew • Brew
• Brew • Brew
• Brew
TT
TT
T
emperaempera
emperaempera
empera
ture = 200°Fture = 200°F
ture = 200°Fture = 200°F
ture = 200°F
• Brew Volume = Set to dispensing vessel requirements (2.2 liters)• Brew Volume = Set to dispensing vessel requirements (2.2 liters)
• Brew Volume = Set to dispensing vessel requirements (2.2 liters)• Brew Volume = Set to dispensing vessel requirements (2.2 liters)
• Brew Volume = Set to dispensing vessel requirements (2.2 liters)
Generally there will never be a reason to change your ADS programming. However, should you need to make slight adjustments
to meet your brewing needs, programming instructions are provided later in this manual.
System Requirements:
• •
• •
•
WW
WW
W
aa
aa
a
ter Sourceter Source
ter Sourceter Source
ter Source 20 – 90 PSI (Minimum Flow Rate of 1 GPM)
• Electrical:• Electrical:
• Electrical:• Electrical:
• Electrical: See attached schematic for standard model or visit www.wilburcurtis.com for your model.
Equipment to be installed to comply with applicable federal, state, or local plumbing/electrical codes having jurisdiction.
SETUP STEPSSETUP STEPS
SETUP STEPSSETUP STEPS
SETUP STEPS
The unit should be level (left to right and front to back), located on a solid counter top. Connect a water line from the water filter to the
brewer. NOTE: Some type of water filtration device must be used to maintain a trouble-free operation. (In areas with extremely hard
water, we suggest that a sedimentary and taste & odor filter be installed.) This will prolong the life of your brewing system and
enhance coffee quality.
1. A 3/8” NPT x 1/4” Flare elbow has been supplied for water line connection. Use tubing sized sufficiently to provide a minimum of
1.0 GPM.
2. Connect the unit to an appropriate electrical power circuit.
3. Turn on the toggle (STANDBY/ON) switch behind the unit. The heating tank will start to fill. When the water level in the tank rises
to the correct volume, the heating elements will energize automatically. With ADS Systems there is no danger of element burnout
caused by an empty tank.
4. The heating tank will require 20 to 30 minutes to reach operating temperature (200°F) as indicated by the READY-TO-BREW
indicator light.
5. Prior to brewing, dispense 12 ounces of hot water through the hot water faucet.
6. Brew a cycle of at least 12 ounces, to purge the water lines of any air that may be trapped after filling.
The National Sanitation Foundation requires the following water connection:
1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) so that the machine can be moved
for cleaning underneath.
2. In some areas an approved backflow prevention device may be required between the brewer and water supply.
BREWING INSTRUCTIONSBREWING INSTRUCTIONS
BREWING INSTRUCTIONSBREWING INSTRUCTIONS
BREWING INSTRUCTIONS
1. Brewer should be ON (Confirm at rear toggle switch, then press ON/OFF button). Ready-to-Brew should be displayed.
2. Place empty airpot on deck.
3. Place filter in brewcone.
4. Pour ground
coffee into
brewcone.
6.Press Brew
button.
WW
WW
W
ILBURILBUR
ILBURILBUR
ILBUR
C C
C C
C
URTISURTIS
URTISURTIS
URTIS
C C
C C
C
OMPOMP
OMPOMP
OMP
ANYANY
ANYANY
ANY
, I, I
, I, I
, I
NCNC
NCNC
NC
..
..
.
5. Position
brewcone
into brew
rails.
WILBUR CURTIS COMPANY
Montebello, CA 90640
CAUTION: CAUTION:
CAUTION: CAUTION:
CAUTION: When
cleaning, DO NOT use
powders, liquids,
cleansers, or any substance
containing chlorine. These
products promote corrosion,
cause pitting of stainless steel and
will void the warranty.