Windmere TO2000 Oven User Manual


 
11
10
This appliance is for HOUSEHOLD USE ONLY and may be plugged into a standard
electrical outlet.
BEFORE USING:
Unpack carefully and wipe outer surfaces with a clean, damp cloth to remove residual
packing debris. Remove wire rack from unit. (See CARE AND CLEANING for directions.)
Wash rack and multi-purpose pan in hot, soapy water, and dry thoroughly. Replace
wire rack.
Before attempting to operate toaster oven, familiarize yourself with the controls (Fig. 2)
to ensure optimum performance.
CAUTION: The temperature of the door or the outer surface may be high when the
appliance is operating.
FOR TOASTING:
1. Remove the multi-purpose pan, set it aside and place up to four slices of bread side
by side on wire rack. (To toast a single slice, center it on the rack.)
2. Turn temperature control dial to Toast position and use timer to select toast shade
(Light, Medium or Dark). Both heating elements (top and bottom) will operate. When
toasting is finished, bell will ring and oven will shut off automatically. NOTE: Remove
bread promptly to avoid over-toasting by residual heat.
3. To interrupt toasting cycle, turn timer counterclockwise to OFF. Timer bell will ring.
For additional toasting time, reset timer and monitor toast visually.
POLARIZED PLUG (120V models only)
This appliance has a polarized plug (one blade is wider than the other). As a safety
feature, this plug fits in a polarized outlet only one way. If the plug does not fit into the
outlet, reverse the plug and try again. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.
LINE CORD SAFETY TIPS
1. Never pull or yank on the cord or the appliance.
2. To insert plug, grasp it firmly and guide it into outlet.
3. To disconnect appliance, grasp plug and remove it from outlet.
4. Before each use, inspect the line cord for cuts and/or abrasion marks. If any are
found, this indicates that the appliance should be serviced and the line cord
replaced. Please return it to our Service Department or to an authorized service
representative.
5. Never wrap the cord tightly around the appliance, as this could place undue stress
on the cord where it enters the appliance and cause it to fray and break.
DO NOT OPERATE APPLIANCE IF THE LINE CORD SHOWS ANY DAMAGE, OR IF
APPLIANCE WORKS INTERMITTENTLY OR STOPS WORKING ENTIRELY.
If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or similarly qualified person in order to avoid a hazard.
ELECTRIC CORD
A short power supply cord is provided to reduce the hazards resulting from
entanglement or tripping over a longer cord. An extension cord may be used with care;
however, the marked electrical rating shall be at least as great as the electrical rating of
this appliance. The extension cord should not be allowed to drape over the tabletop
where it can be pulled on by children or tripped over.
HOW TO USE
OPERATING INSTRUCTIONS
PRODUCT MAY VARY SLIGHTLY FROM ILLUSTRATIONS
Glass Door
Wire Rack
Handle
Carrying
Handles
(on sides
of unit)
Temperature
Control Dial
On Indicator Light
On/Off/Timer
Switch
Multi-purpose Pan
(not shown)
Crumb
Tray
On Indicator
Light
15-minute Timer
Toast Shade Selections
Oven On Position
Temperature Selections
Toast Position
Broil Position
CONTROL PANEL DIAGRAM
FIG. 2
FIG. 4
FIG. 3
FIG. 1
2001_3_22_134_LAG 5/11/01 4:17 PM Page 12