Filter
Top Products
4. Screw the four 1"wood screws
(tor mounting the hood) into the
exact center of the arrow and of
the keyhole mounting slots marked
on the cabinet bottom (for flush
installations), or marked on the
1"x2"wood strips (tor recessed
cabinet installation) (Fig.7)
Do not turn the mounting screws
in all the way. Allow3/8" of screw
to project. so the hood can be
fitted place. (The screws willbe
tightened later)
!!
I
~ -
D D
~'
Fig.?
G. Providing Electrical Power
Note: Please also refer P.11 "J. Making the Electrical Connection'
1.
After turning off the proper 120 volt circuit at the service entrance.
drill out the electrical power line access hole marked on the cabinet
bottom or wall. Use a 1 v.. "wood bit. To operate the electric drill. use
an extension cord connected to another circuit. (Fig.8)
Safety Warning:
Ifdrillingintothe walls. be carefulnotto cut existingelectrical
cabbies. whichwouldcreate a hazard.
.
2. Fish the electrical power line through the access hole drilled in
the wall or bottom of the cabinet. Attach an appropriate connector
(purchased locally) to the end of the power line for the type of wiring
being installed. Follow all codes.(Fig.9)
Color:
green/white/black
Flg,9
-7-