Filter
Top Products
10
WOLF COOKTOP LOW-PROFILE HOOD USE & CARE
CHARCOAL FILTER
If the ventilation hood in used in a recirculating
application, the charcoal filter must be
replaced at regular intervals. The
(F)
icon in
the hood controls will flash to indicate when
the charcoal filter needs to be replaced. This
indicator light flashes after approximately 120
hours of operation. To reset the hour counter,
press the
(F)
control pad while the icon is
flashing.
Charcoal filter removal—wall hood Charcoal filter removal—island hood
CHARCOAL FILTER REMOVAL
First remove the grease filter(s). To access the
filter(s), gently press up on the front edge and
allow the panel to rotate downward as shown
in the illustration on page 9. Push the handle
outward and pull the grease filter downward to
remove.
Then remove the charcoal filter as shown in
illustrations below. Push the catch towards the
inside and turn the charcoal filter so that the
two filter clips slip out of their seats.
Install the new charcoal filter using the reverse
procedure.